F1200

A deburring and grinding machine for sheet metal parts with a width up to 1200 mm. You determine the finish and degree of edge rounding. Depending on the materials to be processed, you can choose between a vacuum and a magnet system. The conveyor belt will be adapted to this.

The first station of the F1200 exists of a grinding head. The abrasive belt removes the burrs and/or incineration points from the product surface. You can decide yourself on the grain size of the abrasive belt, depending on the height and hardness of the burr. Standard there will be a grinding belt grit K120 on the deburring machine. If there are no burrs, you can leave the grinding belt switched off. It is also possible to use a fine grinding belt (e.g. K320) for line graining your product or to finish it with a scotch brite belt.

The second and third station is our so-called brush unit, fitted with 4 counter-rotating, oscillating brushes. This can break the sharp edges of the product and provide them with a large radius. You can also change the surface finish (e.g. more gloss / lower roughness value) by changing the type and grit of the brushes. By placing special steel brushes, you can remove oxide layer or do slag removal on steel product with the F1200 (magnet system).

*Minimal product size with the vacuum version 80 x 80 mm; with the magnet version 50 x 50 mm.

WES6000

WES stands for ‘Wet Extraction System’ and is the easiest, safest and most sustainable way to extract grinding dust according to Q-Fin. With the wet-operating dust extractor, fire and explosion hazards are prevented. Your operators can work in a dust-free area.

The WES6000 wet extraction system can be combined with virtually all our deburring machines, in many cases multiple deburring machines can even be connected to 1 WES extraction system. We can arrange the installation including pipe work if required.

The WES6000 has a suction capacity of 6000 m3/h and that more than sufficient for the F1200.